Bloody Stormtrooper Finn Vinyl Decal
How To Prepare Decal for Application :
It is not uncommon for the transfer tape to separate slightly from the sticker backing in a few places during shipping. This is normal and easy to fix. Simply pull the transfer tape away from the backing about halfway across the sticker. Then replace it slowly, smoothing the area with the flat part of your hand from the middle of the sticker out to the edge. Then repeat this process on the remaining side.
How To Apply Decal :
Step 1 - Clean the area thoroughly with rubbing alcohol or soap and water. Do not use Windex or similar products because it will leave a residue behind that will prevent the sticker from adhering well.
Step 2 - Prepare the sticker for application by firmly rubbing a squeegee or credit card across the clear transfer tape. This removes any air bubbles that may have formed and makes the sticker cling to the transfer tape.
Step 3 - Peel the white paper backing off the sticker. If the sticker clings to the backing, slowly replace the paper backing and repeat Step 2.
Step 4 - Slowly lower the sticker onto the surface and rub it in place firmly with a squeegee or credit card. For best results, wait 24 hours before moving to the next step.
Step 5 - Slowly peel the clear transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.
* Use a pin to poke any air bubbles in the center and push the air out through the hole * The recommended optimum temperature for applying graphics is 70°F. For best results do not apply a sticker in extreme hot or cold temperatures *
Shut up and give me the details :
- White vinyl decal
- Measures 4" x 4"
- Can be applied to any smooth surface